Logical Solutions SCS-R Manuel d'utilisateur télécharger pdf (Page 33)

tel (203) 647-8700 Page 33 Product Manual - MAN-000001C

Front Panel Network SetupSECURE CO NSO LE S ERVERS

When successfully logged in, you will see the command prompt ending with # fol-

lowed by your cursor.

You should change your SCS’s network address as one of the first changes you

make. See Section 7.2, Change Network Address, on page 53.

4.4 Front Panel Network Setup

If you changed the Network settings via netconfig, you can skip this section.

By default, the Front Panel Display and buttons can be used to set the basic net-

work parameters. There is one ‘ENTER’ button and four arrow buttons (Left, Right,

Up and Down). The front panel can change the IP Address, Subnet Mask, and Gate-

way settings. By default, the front panel will show the Hostname and the Date/Time.

Figure 4.4 Default Normal Front Panel Display (Hostname and Date/Time)

4.4.1 Front Panel Edit Mode

By default, the Front Panel Display’s Edit mode is enabled. The View Mode is

similar to Edit mode except that the front panel cannot be used to change the settings.

This is described in Section 7.7, Front Panel Display Options, on page 57 of this manual.

Note

The Front Panel Edit Mode can be disabled, if required. See Section

7.7, Front Panel Display Options, beginning on page 57.

With Edit mode enabled, use the arrow buttons on the front panel to access the

front panel edit subroutine and change the default network settings (showing the IP

address, Netmask, and Gateway) for your SCS system. The front panel controls are

self-prompting for the appropriate entries.

Figure 4.5 SCS Front Panel Display, showing first LCD Mode display

scs.localdomainname

Tue Mar 18 15:53:03 2003

Press Enter to

Program Network Settings

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 89 90

Pas de commentaire

Logical Solutions SCS-R Manuel d'utilisateur Page 33